Also, you’ll need a screwdriver and a drill.Ĩ-Step Guide on How to Wire Multiple Off-Road Lights to One Switchįor our guide below we’ll be using off-road lights connected to the bumper of a Ford as an example. Use a crimp connector to connect wires and the wire stripper for stripping wires. So, remember to pick a high-quality switch.Ĭrimp Connectors, Wire Stripper, Screwdriver, and Drill We use this switch for all the off-road lights. Depending on the amperage of the automotive relay switch, buy the second fuse (a 3 amp fuse is more than enough). Hence, you need to get one fuse for the relay and one for the switch. Remember, we only connect fuses to devices that directly connect to the battery. For both points, connecting a fuse is the safest option. In this process, we have to connect two points to the 12VDC battery. To protect electrical devices on your vehicle, you can use these fuses. (Install with photos will be covered in more detail later) Also, buy a 30/40 amp relay for this wiring process. However, in this demonstration, we don’t use the 87A pin. ![]() Keep in mind: The above method is the accurate way to connect a relay. 87A and 87 go to the electrical components. The number 30 pin connects to the battery. Usually, a relay comes with four or five pins. (We’re going to give you a general rundown of the things you’ll need, don’t worry we’ll go through greater detail in the guide below them).Ī Relay is one of the most useful items in this wiring process. Now your off-road lights are ready for use.įor this process, you’ll need quite a few tools.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |